Tesco Logo 25601 Avenue Stanford
Valencia, CA 91355
(661) 257-0153    Fax (661) 257-0248

TescoEmail@yahoo.com
Serving The Terrazzo & Masonry Industry Since 1928
Home References Products Product Data


Home
Project References
Product Data

SEALERS

Crystal Seal
Crystal Seal II
Crystal Cote
Flash Cote


STRIPPERS, CLEANERS, & SOLVENTS
Stripper
Strip'It
Clean' Brite
Reducer


DIVIDER STRIPS
Divider Strips

MARBLE CHIPS
Marble Chip Selection

TOOLS
Flex Grinding Machines
Border Grinding Machines
Heads for Flex Machines
Clamps & Couplers
Tool List
Abrasive Stones
Diamonds

Maintenance & Care

Credit Application


Contact Us


CRYSTAL SEAL II

  • ZERO VOC'S . . . . . . . . . . 
Best in the market Crystal Seal II
  • ATTRACTIVE . . . . . . . . . .
Highlights natural beauty of marble colors
  • PROTECTIVE . . . . . . . . . .
Water, oil, and grease proof, acid resistant
  • GOES FURTHER . . . . . . .
Covers 250 to 300 sg ft per gallon
  • TOUGHER . . . . . . . . . . . . .
Resistant to cuts and slits Crystal Seal II
  • ECONOMICAL . . . . . . . . . .
Lasts longer under heavy traffic
  • SUPERIOR QUALITY . . . .
Ideal with Alundum, Carborundum, Silicon, Anti-Slip Matrix Installations
   

TESCO Crystal Seal II is formulated with acrydite resins which are extremely high in chemical resistance and also have an extreme hardness.  In fact, they are within four points of plate glass hardness.  TESCO Crystal Seal II has a tack free drying time of 30 minutes; weight per gallon at 60 degrees F. 11.1 lbs.; total solids 15%.  The acrydite resins are non-yellowing; they are as transparent as water and are cut with a combination of hydrocarbon and halogenated solvents which insure a good penetration into the surface.  The acrydite resins are extremely resistant to ultraviolet rays and over long periods of time will show absolutely no discoloration even under exposure to the sun on exterior application, regardless of colors in the matrix in either white or gray cement. 

TESCO Crystal Seal II does not apply a surface coating, but is a complete, highly penetrating process in which it penetrates the matrix, marble, tile or any masonry surface to insure a thorough and complete seal, making the surface impervious to stains of oils, greases, water, acids, or practically any type of common chemical discoloration.

TESCO Crystal Seal II is the only clear resin sealer that permits a permanent exterior application without discoloration and will intensifies color and natural beauty of stone, terrazzo and masonry surfaces. TESCO Crystal Seal II penetrates into pores and increases density and durability, keeping dirt and moisture on top of surface so that they are easily cleaned. Extremely resistant to ultraviolet rays and will not discolor or amber. Tests indicate that TESCO Crystal Seal II has better anti-slip properties than most other sealers.  For this reason TESCO Crystal Seal II has become one of the largest selling sealers for the flooring industry, including terrazzo, epoxy terrazzo, polyester terrazzo, magnesite, marble, slate, tile, brick, cement and concrete.

TESCO Crystal Seal II is used in airports, colleges, malls, banks, aircraft hangars, warehouses and factories where a complete, dust proof, long-wearing surface is required.

TESCO Crystal Seal II is the only clear resin sealer that permits a permanent exterior application without discoloration.

DIRECTIONS:

  1. Clean surface with TESCO Clean'Brite, rinse surface thoroughly and allow to dry completely. When renovating an old floor strip surface with TESCO Stripper and then wash surface with TESCO Clean'Brite, rinse surface thoroughly and allow to dry completely.

  2. Stir TESCO Crystal Seal II well.

  3. Apply TESCO Crystal Seal II to clean, dried area using a lambs wool applicator, natural brush or spray with low-pressure garden-type sprayer.  Mop or rollers are NOT recommended.

  4. TESCO Crystal Seal II is a VERY quick drying seal.  Apply seal in one direction only.  Avoid overlapping. Do not go back over seal just applied as it will re-dissolve original seal, causing gumming or streaking.  Use dividing strip, grout joint, or edges and borders for overlap-joints where possible.

  5. Let TESCO Crystal Seal II penetrate and dry thoroughly (normally 3-4 hours) before exposing to foot traffic.

  6. If a second coat is desired, it is best to allow first coat to dry for approximately 24 hours.

  7. Clean tools, applicators and spray equipment with TESCO Crystal Seal Reducer or Acetone.